al roller_drum_pos rlrpos Trendsetter_VLF Trendsetter_VLF_Auto This parameter places the drum roller just past the LE clamps onto the plate. When the drum is moved to this position and the drum roller is lowered, there should be a 5 to 10 mm gap (safety margin only) between the drum roller and the LE clamps. During a plate load, this parameter is used as follows: the plate is first clamped into the LE clamps the drum is moved to this position the drum roller is lowered onto the drum the plate is wound the rest of the way on to the drum During a plate unload, this parameter is used as follows: the TE clamps are removed from the plate the drum is unwound to this position the drum roller is lifted off the drum the drum is move to the LE position the LE clamps are opened int32

15250

0 to 36,000 (encoder ticks)

This parameter only exists on the VLF Trendsetter because on this machine the LE actuator bar is located above the roller; on all other machines the LE actuator is below the roller so the roller can be lowered as soon as the LE clamps are closed onto the plate. cal

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:35:41 2008 PST